Innov'PA is a fine powder based on polyamide 12 (thermoplastic) especially formulated to function on rapid prototyping systems by laser sintering or radiation. It enables to obtain productions of models and functional parts in "plastic engineering" with long cycle of life and excellent chemical resistance.
This polyamide powder gives final productions in uniform gray color in mass.
The typical applications of Innov'PA 2550 are parts and models of design, functional, precise, requested mechanically, chemically and in temperature.
• Granulometry refined around 45µm
• Excellent resolution of contour and surface for Rapid Manufacturing, low shrinkage material
• Mechanical properties and mechanical behaviour such as injected reinforced parts as a Polypropylene with talc's (PP20%T) allowing Rapid Manufacturing
• Exploitable on any type of system of prototyping: Pluri-manufacturers
• Use continues powder cycles sifting-regenerating with a lowered Regeneration factor
• Aspect and coloring grey of the product, cohesion of layer, possibility to have functional clip with this material
• Behaviour in temperature of the product until 116°C: part for motor as Inlet manifold
• Chemical resistance of composite Polyamide 12
• Economic cost of exploitation (ratio Q Powder / Number of building)
• Provisioning independent of the manufacturers
